Blog

Is it possible to operate two motors parallel with a 9300 Servo and which motor parameters are to be entered? The operation of two asynchronous motors at one servo controller is possible, if the corresponding selection and the following advices are considered: • Only identical motors can be used • They must be coupled shrunk to each other. • Both motors connected parallel are detected by the drive controller as a summated motor. • Only one feedback system is to be conne …

Can you use a HMI (e. g. EPM-H310) with a 8200/8200 Vector Drive or Motec (connected with EMF2171IB or EMF2175IB) to set the speed of the motor? It is no problem to use Lenze AIF modules EMF2171IB or EMF2175IB for the communication between an operating terminal and the 8200. With both modules you can transfer data via parameter channel or process data channel. In the Project Manager of the HMI Designer you have to connect the AIF modules to the CAN-port as if they were drives (as DEVICE_CAN_SLA …

How do I select the Proper Size VFD? For most applications, select a Lenze VFD that has an output current rating that equals or exceeds the nameplate current rating of the motor. Do not just select the VFD based on the motor Hp rating, as this can result in a VFD that is too small. Some severe applications, such as punch presses, vibratory conveyors, mixers, etc, may require oversizing the VFD in order to handle the peak current demands of the load. Please contact AC Tech's Application Engi …